McDATA Eclipse 2640 SAN Manual de usuario Pagina 2

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 26
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 1
Exam Name: McData Certified IP San Specialist
Exam Type McData
Exam Code: MD0-251 Total Questions: 126
Page 2 of 26
© SelfExamEngine.com
Question: 6
Name the protocol which allows for fault isolation between fabrics across the WAN.
A. FICON
B. iFCP
C. TCP/IP
D. TankIO
Answer: B
Question: 7
At Company.com, you work as a network administrator. 100 servers are deemed ineligible for
HBA's and direct attachment to the Fibre Channel fabric, in a data center. iSCSI drivers have
been placed on each server.
Through an Ethernet switch, the servers have 100 BaseT cards and are aggregated. A single
iSCSI gateway (Eclipse 1620) has been attached to a dedicated Ethernet switch via both Gigabit
Ethernet (GE) ports. Name the statement which is true.
A. If packets are dropped, flow control is handled by the Data Link Layer (Layer 2) between the
Eclipse and the Ethernet switch.
B. LUN mapping on the Eclipse should be configured to provide a LUN of 1 to all the servers.
C. Compression between the iSCSI initiator and the iSCSI gateway should be set to auto and
last LZO with History
D. In this case, Eclipse iSCSI ports support a fan-in of 50 to 1 without oversubscription. The
ports on this iSCSI gateway are oversubscribed by 2:1.
Answer: D
Question: 8
Name the default baud rate setting of the serial port on a McDATA Eclipse SAN Router.
A. 9600
B. 115200
C. 2400
D. 57600
Answer: A
Question: 9
What is returned to the server from the Fibre Channel Switch, when a server initiates a FLOGI?
A. a register state change notification
B. the name of the switch
C. the server's Fibre Channel address
D. the switch's Fibre Channel address
Answer: C
Question: 10
The increments defined are in __________ Kbps, when using a number to configure the Ethernet
port speed.
A. 3000
B. 1.5
Vista de pagina 1
1 2 3 4 5 6 7 ... 25 26

Comentarios a estos manuales

Sin comentarios