McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 Guía de usuario descargar pdf (Pagina 93)

100

101

Configuring an E_Port Extension over an Ethernet WAN

5-17

Configuring a 1x1 Ethernet Wide Area Network

NOTE: If you do not know what the default gateway (the router IP address

attached to the UltraNet Edge 3000) is at this point, you can add the static

route at a later time. To add static routes at a later time, see Appendix E, Static

Routes.

15. Check Set, enter the IP Address of the router directly attached to

Node20 to set the static route.

NOTE: If you are using the Configuration IP Address Worksheet, enter the

following information:

For Node20, enter the gateway address labeled for the circuit on a 1x1 or

2x1 configuration or the 1st circuit of a 1x2 or 2x2.

For the 2nd circuit of a 1x2 or 2x2 configuration, enter the gateway address

labeled .

16. Click Next>.

The IP Circuit Wizard Configure Circuit dialog box appears.

This dialog box enables you to configure the circuit properties.

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 427 428

Comentarios a estos manuales

Sin comentarios

McDATA ULTRANETTM EDGE STORAGE ROUTER 3000 Guía de usuario Pagina 93

Comentarios a estos manuales

Relacionado con productos y manuales para Redes McDATA ULTRANETTM EDGE STORAGE ROUTER 3000