McDATA Eclipse 2640 SAN Manual de servicio descargar pdf (Pagina 43)

Installing and Connecting the 2640 SAN Router

2-7

To set the SAN Router IP address, you can connect a terminal to the

RS-232 port on the SAN Router or access the SAN Router via Telnet

or embedded Web-based management on the 10/100 management

port using the default management IP address.

Task 5: Connecting the VT100 or Emulation Terminal to the RS-232

Management Port

To connect the terminal:

1. Use a null modem cable to connect a VT100 terminal or any

standard PC running terminal emulation software to the RS-232

serial port (

Figure 2-2) on the SAN Router.

Table 2-2 Default Management and SAN Router Addresses

Port IP Address Subnet Mask Default Gateway

Mgmt 192.168.100.100 255.255.255.0 0.0.0.0

Table 2-3 Other Defaults

Parameter Default Setting

Zoning No zone (No devices zoned by default)

iFCP SAN ID 0

FC Port Type FC - Auto

Intelligent Port Interface Depends upon the configuration purchased.

Intelligent Port Type Depends upon the configuration purchased.

E_Port Zone Policy Append router zones

Compression Off

MTU Auto

Auto Reset on Severe Errors Enabled

Fast Write Off

Serial Port 9600, 8, none,1, none

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 101 102

Sin comentarios

McDATA Eclipse 2640 SAN Manual de servicio Pagina 43