McDATA Eclipse 2640 SAN Manual de servicio descargar pdf (Pagina 94)

5-4

McDATA Eclipse 2640 SAN Router Installation and Service Manual

RRP 2: Redundant Power Supply

Use the following procedures to remove or replace a redundant

power supply (with internal cooling fan) from the rear of the router

chassis.

Tools Required A door key with 5/16-inch socket may be required for some

equipment cabinets.

Removal To remove a redundant power supply:

1. If the router is installed as part of a stand-alone configuration,

skip this step. If the router is rack-mounted and installed in a

cabinet, open the cabinet front door.

2. Review in either Element Manager or SANvergence Manager to

verify the error which is reported as an SNMP alert or alarm. The

error message which include which power supply has failed.

DANGER

Disconnect the power cord. (D005)

3. Disconnect the power cord from the defective power supply.

4. Remove the power supply by unscrewing the thumb screws.

5. Pull the power supply out by the handles as shown in Figure 5-1.

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 100 101 102

Sin comentarios

McDATA Eclipse 2640 SAN Manual de servicio Pagina 94