McDATA OPENconnectors Command Line Interace Manual de usuario descargar pdf (Pagina 171)

CLI Commands

2-127

perf

perf.thresholdAlerts.deleteAlert

Syntax deleteAlert name

Purpose This command deletes a specified threshold alert.

NOTE: An alert cannot be modified unless it is in the disabled state. Verify

that the alert is disabled before executing this command.

Parameters This command has one parameter.

Command Example

Root> perf thresholdAlerts deleteAlert checklinks

perf.thresholdAlerts.setState

Syntax setState name enabledState

Purpose This command sets the enabled state of the specified threshold alert.

Parameters This command has the following parameters.

Command Example

Root> perf thresholdAlerts setState checklinks enabled

perf.thresholdAlerts.show

Syntax show

name The name of a threshold alert as defined by the

commands perf.thresholdAlerts.counter.addAlert

and perf.thresholdAlerts.throughput.addAlert, or,

enter all to delete all of the configured

threshold alerts.

name The name of a threshold alert as defined by the

commands perf.thresholdAlerts.counter.addAlert

and perf.thresholdAlerts.throughput.addAlert.

enabledState Sets the counter threshold alert enabled state.

Valid values are enable and disable. Boolean 1

and 0 values may also be substituted.

1 2 ... 166 167 168 169 170 171 172 173 174 175 176 ... 327 328

Sin comentarios

McDATA OPENconnectors Command Line Interace Manual de usuario Pagina 171