McDATA OPENconnectors Command Line Interace Manual de usuario descargar pdf (Pagina 53)

CLI Commands

2-9

config

Purpose This command sets the enabled state of the OpenTrunking feature.

The OpenTrunking feature key must be installed in order to enable

open trunking.

Parameters This command has one parameter.

Command Example

Root> config features openTrunking 1

NOTE: The command perf.openTrunking.setState on page 2-107 has

functionality that is identical to this command.

config.features.show

Syntax show

Purpose This command shows the product feature information configured for

this switch.

Parameters This command has no parameters.

Command Example

Root> config features show

Output The product feature data is displayed as a table that includes the

following properties.

openTrunkingState This parameter can be set to enable or disable

the OpenTrunking feature. Boolean 1 and 0

may be substituted as values.

Installed Feature

Set

The feature set installed using a feature key.

Only installed keys are displayed.

Feature Individual features within each set. In many

cases, there is only one feature within each

feature set.

State The state of the individual feature. Fabric-wide

features are displayed as Active/Inactive.

Features related to the switch are displayed as

Enabled/Disabled.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 327 328

Sin comentarios

McDATA OPENconnectors Command Line Interace Manual de usuario Pagina 53