McDATA OPENconnectors Command Line Interace Manual de usuario descargar pdf (Pagina 179)

CLI Commands

2-135

perf

perf.thresholdAlerts.throughput.show

Syntax show name

Purpose This command displays the settings for an individual throughput

threshold alert.

Parameters This command has the following parameter.

NOTE: The output of this command truncates threshold alert names that are

longer than 51 characters. If you specify lengthy names, you can display the

complete name by entering the comma-delimited mode using the

commaDelim command. For more information, see Using the commaDelim

Command on page 1-17.

Command Example Root> perf thresholdAlerts throughput show eportRx

Output Example The output from the perf.thresholdAlerts.throughput.show

command displays as follows.

Name: 90% Receive Throughput Threshold

Ports: 5,8,12,20-24

Utilization Type: Rx

Utilization Percentage: 90%

Duration: 15

Interval: 30

Alert State: Disabled

perf.thresholdAlerts.throughput.showUtilTypeTable

Syntax showUtilTypeTable

Purpose This command displays a table of the utilization types that can be

used for a throughput threshold alert. This table is used for reference

only.

name The name of a throughput threshold alert

as defined by the command

perf.thresholdAlerts.throughput.addAlert,

described on 2-129.

You can specify all instead of a name, which

means that all threshold alerts are

displayed.

1 2 ... 174 175 176 177 178 179 180 181 182 183 184 ... 327 328

Sin comentarios

McDATA OPENconnectors Command Line Interace Manual de usuario Pagina 179