McDATA OPENconnectors Command Line Interace Manual de usuario descargar pdf (Pagina 229)

CLI Commands

2-185

show

show.snmp

Syntax snmp

Purpose This command shows the switch SNMP configuration.

Parameters This command has no parameters.

NOTE: The command config.snmp.show on page 2-71 has functionality that is

identical to this command.

Command Example Root> show snmp

Output The switch configuration data is displayed as a table that includes the

following properties.

SNMP Agent

State

The state of the SNMP agent. If it is disabled,

the SNMP state does not respond to any

requests and does not produce any traps.

FA MIB Version

Number

Version of the MIB that the SNMP agent is

configured to use.

Authentication

Traps

The state of the authentication traps (for

example, enabled) that are sent to SNMP

management stations when unauthorized

stations attempt to access SNMP information

from the switch.

Index

The community index number.

Community Name

The name of the community.

WriteAuth

The write authorization state.

Trap Recipient

The address of the trap recipient shown in

4-byte dotted-decimal format.

UDP Port

The user datagram protocol (UDP) port number

to which the director or switch will send traps

for each recipient.

1 2 ... 224 225 226 227 228 229 230 231 232 233 234 ... 327 328

Sin comentarios

McDATA OPENconnectors Command Line Interace Manual de usuario Pagina 229